Goniometer (Rame-Hart A-100) - Operating Procedure

From UCSB Nanofab Wiki
Jump to navigation Jump to search

System Illustration

labeled photo of the contact angle goniometer
The Ramé-Hart A-100 Contact Angle Goniometer and relevant adjustment knobs.

Measurement Procedure

To measure the contact angle of water on a surface, perform the following procedure.

  • Note that the image through the scope is inverted upside-down.
  • You will also see a reflection of the water droplet on your polished substrates, as illustrated here:
Illustration of a reflective sample.
View through the scope: Illustration of a reflective sample. Substrate is on top due to inverted image.


Goniometer (Rame-Hart A-100) - Steps for Measuring v1.png

Alternate Measurement Technique - Tilt Angle

An alternate, "quick and dirty" method for comparing hydrophobicity between surfaces is to drop an identical amount of water on each sample's surface, and tilt the sample until the drop rolls off - the tilt angle required can be compared. This technique is much more "noisy" than the goniometer, but can be done without highly specialized equipment.