Difference between revisions of "Template:Announcements"

From UCSB Nanofab Wiki
Jump to navigation Jump to search
(holiday fire update)
(stepper 3 wafer stuck)
Line 9: Line 9:
 
<!------------- Announcements ---------------->
 
<!------------- Announcements ---------------->
   
===== LAB OPEN =====
+
===== ASML Stepper 3: Wafer stuck =====
  +
There is a wafer stuck on the D-Chuck. Will email when it's been removed.
The Nanofab is open following wildfire-induced power outages. The tools below are still down and we are working to get them running. We'll send out an email for each tool below when it is ready to run.
 
 
// [[User:John d|John d]] 19:02, 14 July 2018 (PDT)
   
* Ebeam #4 is in regen
 
* IBD
 
 
The Holiday Fire is expected to be at full containment by July 11th.
 
// [[User:John d|John d]] 08:17, 9 July 2018 (PDT)
 
   
 
===== PlasmaTherm SLR: Down =====
 
===== PlasmaTherm SLR: Down =====
The SLR fluorine etcher is down, the turbo has failed. Will work on it on Monday.
+
The SLR fluorine etcher is down, the turbo has failed.
 
// [[User:John d|John d]] 22:04, 6 July 2018 (PDT)
 
// [[User:John d|John d]] 22:04, 6 July 2018 (PDT)
   

Revision as of 19:02, 14 July 2018

UCSB NanoFab Announcements

ASML Stepper 3: Wafer stuck

There is a wafer stuck on the D-Chuck. Will email when it's been removed. // John d 19:02, 14 July 2018 (PDT)


PlasmaTherm SLR: Down

The SLR fluorine etcher is down, the turbo has failed. // John d 22:04, 6 July 2018 (PDT)

PECVD#1: Software Upgrade

We are going to upgrade the computer and software on PECVD#1 in 2–3 weeks. The tool will be down for three to five days. Once the upgrade is complete, everyone will need to be retrained on the new software. You should start planning accordingly, if you use this tool. We will send out an email when we know the exact dates. // John d 15:05, 20 June 2018 (PDT)

RIE#5: SiCl4 Issue

We have a flow rate problem on the SiCl4 gas line. You can only flow the SiCl4 for 5 minutes and then you have to wait 5 minutes before you flow it again. So in order to to do a 10 minute Etch you will have to do it in three steps flow 5 mi, wait 5mi, then flow 5min. // John d 17:22, 15 June 2018 (PDT)