Logitech WBS7 - Procedure for Wax Mounting with Spin-On Crystalbond

Work In Progress This article is still under construction. It may contain factual errors. Content is subject to change.

Draft only - in progress.  -- Demis 2018-10-16

• Mix a fresh squirt bottle of CrystalBond diluted with Acetone (see Don Freeborn for method).
  • XYZ grams of crystalbond, mixed into
  • XYZ mL of Acetone, in dedicated squirt bottle
  • Shake/stir to completely dissolve the wax
• Place 4-inch silicon carrier wafer on POLOS spinner in solvent bench, with non-vacuum 4-inch chuck installed.
• Set up POLOS recipe
  • Spin at XYZ rpm for XYZ sec.
• Squirt wax solution onto wafer
• I/O to spin.
• Place carrier wafer on Logitech bonder surface
• Place sample to be bonded on top
• Place 110mm chemical filter paper on top
• Close lid, secure lid clamp
• Run recipe:
  • XYZ °C
  • XYZ seconds
  • Vacuum etc.?