Difference between revisions of "Oven 4 (Thermo-Fisher HeraTherm)"
Jump to navigation
Jump to search
(added info, needs verification) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 2: | Line 2: | ||
|picture=Oven4.jpg |
|picture=Oven4.jpg |
||
|type = Lithography |
|type = Lithography |
||
| − | |super= |
+ | |super= Brian Lingg |
|location=Bay 6 |
|location=Bay 6 |
||
|description = Programmable Oven |
|description = Programmable Oven |
||
| Line 13: | Line 13: | ||
== Specifications == |
== Specifications == |
||
| − | * Maximum Temperature = |
+ | * Maximum Temperature = 330 C (no active cooling) |
* Gases: N2, manually set with needle valve (not programmable) |
* Gases: N2, manually set with needle valve (not programmable) |
||
* Multi-step programmable temperature ramps |
* Multi-step programmable temperature ramps |
||
Revision as of 10:18, 15 April 2020
|
About
This oven is often used for long thermal cures and wafer bonding. It has programmable temperature ramps and hold times, but the ramp rate is only "low/med./high" (not an exact ramp rate). A manual needle valve for nitrogen purge has been installed on the back of the oven.
Specifications
- Maximum Temperature = 330 C (no active cooling)
- Gases: N2, manually set with needle valve (not programmable)
- Multi-step programmable temperature ramps
- Programmable atmospheric purge (for cooling)
Documentation
| To Do: User Manual |